|
Adjustment
Instructions
1). To adjust draw length, loosen bolt in Slot 'A", then
remove bolt in Slot "B".
2). Slide module to appropriate draw length hole.
3). Re-install bolts and tighten.
4). Move draw stop to fine tune draw length.
Valley
Adjustment
To increase valley, move your draw length module one
less hole than your desired length and leave draw stop
position the same. This will increase valley.
Example
You are a 29" draw length and want to increase the
amount of valley. move module to the 28" draw length
hole and leave your draw stop position the same. |
